ZEN2GBT TECHNICAL DATA:
Safety: Obstruction sensor, IP 44 rated
Colour: Powder coated Silver on Aluminium, Cool White LED lights
Material: Aluminium Extrusion Powder Coated. Scratch-Resistive PVC Plastic
Installation Hole Size: 102mm
Rated Voltage: AC110-250v
Rated Power: 50/60 Hz Module
Configuration: 2 x NZ/AU Sockets, 5 volt (2.1amp) USB charging outlet x 1, Bluetooth module and speaker.
Cable: 1.75m
ZEN2GBT OPERATIONAL DATA:
1. Press lid for at least 3 seconds to turn on.
2. Once turned on, the LED lights will flash. The unit is ready for use.
3. To raise the socket unit, touch the lid whilst it is flashing. It will automatically rise to full height.
4. To lower the socket unit press the lid whilst the unit is flashing to retract. The socket unit can be stopped at any height whilst is moving by simply touching the lid.
5. To turn off, press the lid for 3 or more seconds and the unit will stop flashing.
6. To turn the Bluetooth speaker on, press the round button in the middle of the speaker for 5 seconds with your finger, after which the unit will say "Hello Grace is pairing".
7. Please remove finger and go into your setting on your device and makes sure your Bluetooth is on and connect to "Grace". When requested enter the pairing "0000". Your device will now be connected.
8. To disconnect your device, hold down the button in the middle of the speaker for 5 seconds, once the socket unit says "goodbye" you can remove your finger. The Bluetooth module is only compatible with HGZN-NS series products.
ZEN2GBT INSTALLATION INSTRUCTIONS:
1. Check that there is sufficient space for the unit prior to purchasing and drilling holes.
2. Make sure the unit can operate freely and can sit flush.
3. Ensure you have an appropriate power supply ready.
4. Make sure that the holes is positioned in a place that complies with local building regulations – see your electrician.
5. Use the recommended hole saw size of 102mm. If possible, practice drilling a hole on a spare piece of material.
6. Remove mounting ring by turning anti-clockwise.
7. Place the cable through the hole and lower unit into it, so it sits flush with the bench/table top.
8. Replace the mounting plate by screwing it back on.
9. Plug in power lead and the unit is ready to operate.
